1. Substation speaker
2. Substation MIC
3. Substation alarm key (call)
4. Substation installing bottom case
5. Supporting post of installing bottom case
Ⅱ. Technical Parameters:
Output power of substation speaker: 350mW
Metal enclosure dimension: 235×170×1mm(LxWxH)
Installing bottom case dimension: 210×150×58mm(LxWxH)
Communication distance: 80m(0.2mm2); 200m(0.5mm2); 300m(0.75mm2);
Ⅲ. Installation and Operation:
1. The substation is installed the separate points for intercom.
After the connecting installation as the connecting method shown in
the master station connection figure successfully, press the power
switch of master station, the power indictor light will be on which
means the normal state of the power.
2. When you want to send an alarm from substation to master station
and enter the intercom, if there is an alarm from any substation to
the master station (press Alarm key of substation), the
corresponding substation indictor light in the master station will
blink and keep in red, and there will be music alarm with the master
station. The music will not stop till you press the corresponding
switch of the substation in the master station, and the indicator
light will turn to green. At the time, the intercom between master
station and substation is available (press Intercom key in master
station to enter the talk and release the key to listen to the talk
in substation). If there are other alarms from substations to the
master station, the corresponding indicator light of substation is
master station will blink in red without music alarm, the indicator
light of substation will turn to green when you press the
corresponding switch of substation in master station.
3. The substation is installed in embedded way.